How to install rainproof power supply

Firstly, the most important its must be installed vertically and the wiring terminals downwards, because most of rainproof power supply are use cover shell to prevent rainwater from entering. Once water enters, it will cause the PCB board to short-circuit and burn out the power supply.

Secondly, for the heat dissipation, distance of 10cm from 4 sides (up/down/right/left) and 5cm from the ventilation hole side should be kept.

Third, during installing, please according to wire connecting sketch map on the product label to do wire connection. The "N” and "l line on the sketch map means the Neutral line and the Live line. The "E” is for Earth line, the "+” is outgoing positive pole, the"_” is outgoing negative pole.

Forth, ensure that all driver wire connections are correct after the product is installed and that heat dissipation is properly addressed within the fixture. Ensure the wiring connections are airtight and waterproof. Only after these requirements are sufficiently met can the driver be operated

*Please read the instructions carefully before installation and preserve it well. 

*Recommend, the lamp must be installed and assembled by a qualified electrician. 

*The mains supply should be turned off before installation. 

*Do not turn the lamp on before the end off the installation. 

*Please use proper wire for connection. 

*The installation of power supply into circuits with large inductive loads or voltage surges should be avoided. 

*The output leads should be kept separate and apart from input leads. 

*The length of output leads should be typically 0.5m-2m in order to keep radio interference minimum. 

*Always ensure that the correct type of Led Strip is used and that the maximum rating is not exceeded. 

*The label power of LED strip must match the output power of the power supply. 

*The power supply is for indoor and outdoor use. 

*It is not intended that this product is used by children, or persons with reduced physical, sensory or mental capabilities.

you can download installation instruction at support or contact us for technical support. Thanks